Many little things can go wrong in your day to make your mood turn. Being stuck in a bathroom with a flushing toilet that won’t flush, is both infuriating and embarrassing.
Especially more so if you share the bathroom with other people. Even more so, when they know you used it last; you get the idea. Well, however devastating this situation might be, it is a common problem and therefore, has commonplace solutions.
The first and foremost of which is to find out exactly what is the problem. Yes, we know the primary problem is ‘it won’t flush’, but we need to be certain of the cause behind it. Here are some of the reasons why it won’t flush and solutions.
Toilet Won’t Flush – Top Solutions
✓ Clogged, plain and simple
In case your toilet is clogged, then you need to unclog it, using a plunger, or drain snake wire, or store-bought or homemade drain cleaner. In the worst-case scenario, you may have to reach down the drain and pull out whatever solid object such as a toy, is creating the blockage.
However, usually a plunger works fine, and there is no need for such drastic measures. It’s advised to maintain precaution around the toilet and make sure you or the kids don’t send stuff down the toilet that doesn’t belong.
✓ Not Enough Water in the Tank
The toilet uses the water from the tank to flush into the bowl, and if there is no or low levels of water in the tank, it won’t flush. Check that the valve that controls the water supply to the tank is turned on. There is an overflow tube in the tank, and ideally, the water level should reach one inch below that.
If it is not so, then that is what’s wrong with the flush. If the valve is turned off mistakenly; then turn it back on and make sure it fills up to the mark. It should work just fine after that.
✓ Broken Flapper
This is another, common occurrence. The flapper is a rubber device at the bottom of the toilet tank that controls water flow from the tank to the bowl. It also closes the tube when the water in the bowl is sufficient. Remove the tank lid and check the flapper, if it is broken you will need to replace it.
Fortunately, it is quite an easy task, and you won’t need to shell out for a plumber to get it repaired. However, a step to step guide to do the same is not in the limits of this article.
✓ Issue with the Chain
As you might have guessed, when you pull the flush lever, a chain pulls on the flapper to release the water in the bowl. Sometimes the chain gets disconnected or loose. Open the tank and check the chain connecting the flush lever and flapper.
If need be adjusted the chain length or replace it in case it has been broken or damaged. Once you do that, the flush should work fine.
Apart from these reasons, there can be some others, not directly related to the tank or the bowl cleaner. In case the blockage is in the drain itself and not the toilet, the drain cleaner solution of unclogging should work fine.
Also, the low pressure of water in the bowl could be due to low water pressure in the main supply, in which case you should get it checked. In case none of these works or seem to be the cause, it is better to leave it to the professionals.